****** Update at your own risk !!!! ******




How to do:

0. Download the upgrade Pack and the version you want. 

1. Unzip all files into a directory of you choice (e.g. C:\CAM)

2. Put your funcard in the programmer and erase it.

3. Open the program you normaly use to write files on a funcard and Erase the funcard.
   Load the flash file (from the map MR103 > fun5) in that section.
   Load the file mr103_512_11.hex in the external eeprom section en write the card.

Go to the setup of your receiver and open the section where the Common Interfase module is.

4. Open the MR section and go to Download section.
   (Can't describe the real name, cause that's depending from your receiver)

5. The messages "Erasing old data, please wait..." and "Insert card 1 or serial dummy card" will be shown.

6. Insert the first smart card and press Ok.

7. The message "Card inserted, opening" is shown, and after that "Performing smart card download..." and wait until

8. the message "Download card completed" appears take the card out and press "Please, extract it"

9. After that, a message "Insert card 2" will be shown.

10.Follow the options as above until the last card has finished downloading using the eeprom file mr103_512_21.hex for card number 2 and mr103_512_31.hex for card number 3.

11.After the last smart card is downloaded, the message "Download complete. Copying image and re-booting" will be shown. Just wait a few moments.


If the new version of software is not shown after about 1 minute, re-insert the module without any smartcard.

When this also doesn't work, completely shut off the receiver once.

Notice: If you're zapping the first time, do not insert any card.
If some decoded channels could be watched, it works fine.





****** Update at your own risk !!!! ******